OutBack MX60 MPPT Charge Controller

Store Learn Residential Commercial Installers Support About Us

1.800.810.9939

Site Map

View Cart

Check Out

Store

OutBack MX60 MPPT Charge Controller
Item Code : 1326

Discontinued

OutBack MX60 60 amp Charge Controller

8/15/08 OutBack is discontinuing the MX60 for the new FLEXware 60 Charge Controller.

Rated for up to 60 amps of DC output current, the OutBack MX60 can be used with battery systems from 12 to 60 vdc with a PV open circuit voltage as high as 140 voc. The MX60's set points are fully adjustable to allow use with virtually any battery type, chemistry, and charging profile.The OutBack MX60 allows you to use a higher output voltage PV array with a lower battery voltage - such as charging a 24 vdc battery with a 48 vdc PV array. This reduces wire size and power loss from the PV array to the battery location while maximizing the performance of you system and saving you money!The OutBack MX60 comes standard with an easy to use and understand display. The four line, 80 character, backlit LCD display is used for programming and monitoring of the system's operation including built-in Data Logging with 64 days of memory.

Outback Charge Controller and Accessories Sizing Recommendations for MPPT Charge Controllers:
Please remember that the amperage rating for MPPT Charge Controllers is based on the output current to the battery. The Charge Controller should be sized so that it equals approximately 80% of the incoming PV array amperage. For example, the input array amperage on an MX60 should be limited to 42 amps in order to obtain the maximum boosting advantage to the battery

SPECIFICATIONS	MX60
Output Current Rating	60 amps DC Maximum at 12, 24 or 48 VDC
Nominal Battery Voltage	12, 24, 32, 36, 48, 54 or 60 VDC (programmable)
PV Open Circuit Voltage	125 VDC Maximum
Standby Power Consumption	Less than 1 watt typical
Charging Regulation Methods	Five Stage: Bulk, Absorption, Float, Silent, Equalization
Voltage Regulation Setpoints	13 - 80 VDC
Equalization Voltage	Adjustable 1.0 to 5.0 VDC above Bulk Setpoint
Temperature Compensation	Programmable slope -2.0mV/oC/Cell to -5.0mV/oC/Cell
Voltage Step-Down Capability	Can charge a 12 or 24 VDC battery from a 48V nominal PV array
Power Conversion Efficiency	99.1% @ 40 amps Output 97.3% @ 60 amps Output
Digital Display	4 line 80 character backlit LCD Display
Remote Interface RJ	45 Modular Connector CAT 5 Cable 8 wire
Operating Temperature Range	-40 to 60°C Power derated above 25°C
Environmental Rating	Indoor Type 1
Conduit Knockouts	Two 3/4 - 1” on the back; One 1” - 1 1/2 “ on each side; Two 1” - 1 1/2” on the bottom
Warranty	Two years parts and labor Optional Extended Warranty
Dimensions (HxWxD)	14.5 “ x 5.75” x 5.75” (368 x 146 x 146 mm)
Shipping Dimensions(HxWxD)	17.75” x 10” x 7” (451 x 254 x 178 mm)
Shipping Weight	12 lbs. (5.4 kg)

Products

Recently Viewed Items

Newsletter

Rebates