Solar Force Piston Pump 3020 12B (Battery)

Home Store Learn

1.800.810.9939

Site Map

View Cart

Check Out

Support

Store

Solar Force Piston Pump 3020 12B (Battery)

Solar Force Piston Pump 3020 12B (Battery)
Item Code : 276
Our Price : $ 1,399.00

Solar Force Piston Pump 3020 12B (Battery)

Solar Force Piston Pump draws water from a shallow well, spring, pond, river or tank. It can push water uphill and over long distances for home, village, irrigation or livestock uses. It can use power directly from a photovoltaic array, or from storage batteries, to fill a storage tank or to pressurize water.

Ultra-Efficient: Uses less power than any other pump in its range

Economical: Reduces power system cost by 25-75% compared to centrifugal or AC pumps

Solar-Direct Application: Starts pumping in low light conditions

Pressurizing Application: DC version is most efficient. AC version uses a low-surge permanent magnet motor that greatly reduces starting surge, inverter size, and wire size requirements (when compared to conventional AC pumps).

Rugged and Reliable: Proven design with a 20–year life expectancy. Simple to maintain with common tools (5-10 yr. maintenance interval)

Good Tolerance for dirt and dry run

Mechanical Drive: allows engine or hand-lever backup.

Illustrated Instruction Manual: makes it easy for anyone to install and service, with no previous experience.

Construction

Cast iron body
Brass cylinder and valve seats
Leather cup piston seals
Neoprene valve seals
Oil-bath crankcase
Gear (timing) belt drive on PV models
Standard V-belt on B models
Pressure relief valve
Permanent Magnet DC Motor
Surge tank included (not in photo)

Suction Capacity

25 vertical feet (7.6 m) at sea level. Subtract 1 foot for every 1000 ft. elevation (1 m for every 1,000 m). Suction capacity may be further limited by intake pipe friction. Intake piping should be minimum 1” (3010, 3020 models) or minimum 1 1/4” (3040). For best reliability, place the pump as close to the water source as possible.

System Requirements

Solar-Direct Systems: Chart indicates power (w) required at the pump. The rated power of the PV array must exceed this number by 20 % or more. A pump controller (linear current booster) is required for the pump to start and run in varying light conditions. A solar tracker may be used to increase daily yield (40-55 % in summer).
Pressurizing Systems: battery power system, pressure switch, and pressure tank of minimum 60 gallon (230 l) size (captive-air tank, available locally)

Voltages Available:

12, 24, 48 VDC, Note: PV-Direct full working voltage is typically 20% higher than nominal (example: 29 Volts for a 24V system)
115V or 230V AC, 50-60Hz

Fittings